The Troubleshooting of Lubrication Equipment: Part B

Lubrication Equipment

The Troubleshooting of Lubrication Equipment: Part B

Ⅰ. Troubleshooting:

5. Lubrication alarm

The pressure gauge replacement hydraulic bit zero:

(1). The switch of the pump drive motor due to overload trips, check the pump and motor, if necessary, replace the motor and pump;

(2). The pump relief valve is broken or not set correctly, check the relief valve be adjusted, if necessary, to be replaced;

(3). The pump suction filter clogging, the dissolution of the cleaning, replace if necessary;

(4). Pump oil absorption, cavitation, inspection, dismantling, check the oil-absorbing side screws on the pump, if necessary, tighten;

(5). Level below the pump suction port, refueling and pump and system oil as part of the exhaust.

The pressure gauge shows oil pressure is too high:

(1). Progressive distributor plug, remove the progressive distributor and, if necessary, cleaning, note that the Pistons are not interchangeable and must be installed in the original position;

(2). Downstream of the progressive distributor pipes get clogged, and respond to the pipe to check.

Time setting error:

(1). The total monitoring time for progressive distributor below the oil cycle, should be re-set;

(2). The progressive distributor and splitter movement indicates the sensing distance of the rod beyond the sensing range, sensing range of the proximity switch should be re-adjusted, not more than 1mm

(3). Progressive distributor on the proximity switch is damaged, inspect, and replace if necessary.

Ⅱ. System check

In order to ensure that the system of long-term safe and stable operation, we recommend to check the oil Lubrication equipment in accordance with the following requirements.

Equipment	Checking Items	Inspection cycle	Inspection time
Reservoir	Damaged or not; oil spills or the liquid level is too low	According to the usage	About 0.1h
Filters	Damaged or not; plugged; replace the parts if necessary	2 months	About 0.2h
Piping, Connectors,	Damaged or not; leakage; replace the parts if necessary	2 months	About 0.2h
Threads Connectors	Damaged or not; fasten again	12 months	About 0.3h
Pumps	Damaged or not , oil spills, working properly	3 months	About 0.1h
Compressed air treatment equipment	Inspection, cleaning filter elements	6 months	About 0.2h

Pre Page: Grease And Oil Lubrication System... Next Page: The Troubleshooting of Lubrication...

Product (427)

Products List (16)

Certificates (4)

News (24)

Hydraulic Manifold Blocks (7)

Hydraulic Control Valves (1)

Hydraulic Cartridge Valves (6)

Industrial Hydraulic Pumps (22)

Electromagnet Solenoids (18)

Lubrication Equipment (28)

Electronic Amplifiers (8)

Hydraulic Power Systems (10)

Hydraulic Hose Fittings (7)

Transporation Information (1)

Credit Report

Products Index

Company Info

Lubrication Equipment